BV1000I specification sheet

Features:

Automatic Voltage Regulation (AVR)
Automatically steps up low voltage and steps down high voltage to levels that are suitable for your equipment.

Wall-mount holes
Allow flexibility for setup in tight locations and mounting on wall or other surfaces.

Sleek design
Slim, modern design can be upright, flat, or wall-mounted to comfortably fit any electronics set-up and complement home décor.

Boost Automatic Voltage Regulation (AVR)
Preserves battery life and maximizes runtime by correcting low voltages without discharging the battery.

Cold-start capable
Provides temporary battery power when the utility power is out.

Transformer-block spaced outlets
Protect equipment with input transformer blocks without blocking access to other receptacles.

Intelligent battery management
Maximizes battery performance, life, and reliability through intelligent, precision charging.

Advanced Safety Features
Safeguard your Home UPS from overloads, excessive mains voltages, short circuits, installation mishaps and battery damage due to low voltage situations.

Battery failure notification
Provides early-warning fault analysis on batteries enabling timely preventive maintenance

Battery backup and surge protection
Outlets provide abundant runtime for network gateway equipment and other critical low-power devices, allowing for hours of internet access during a power outage.

Battery and surge protected outlets
Back up and protect your hardware and data during power outages, surges and spikes.

Safety-agency approved
Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.

LED Indicators
Provide easy-to-read status of the unit and utility power conditions.

Audible alarms
Provides notification of changing utility power and UPS power conditions

Specifications:

©2026 Respective owners and brand holders. This table has been carefully researched and generated by ComXpert International CC (//www.comx-computers.co.za), however, errors and omissions may occur. Only references to South Africa apply. All products are sourced in South Africa from the official suppliers and the warranty is that of the local supplier. E&OE. This table and our site's content may be used on condition that this notice and link remains intact and unaltered.
Specifications
Product Code	BV1000I
Output
Output power capacity	600Watts / 1.0 kVA
Max Configurable Power (Watts)	600Watts / 1.0 kVA
Nominal Output Voltage	230V
Output Frequency (not synced)	50/60 Hz +/-1 Hz
Topology	Line Interactive
Waveform type	Stepped approximation to a sinewave
Output Connections	(6) IEC 320 C13 (Battery Backup)
Transfer Time	6ms typical : 10ms maximum
Input
Nominal Input Voltage	230V
Input frequency	50/60 Hz +/- 5 Hz (auto sensing)
Input Connections	IEC-320 C14
Cord Length	1.52meters
Number of Power Cords	1
Batteries & Runtime
Battery type	Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
Typical recharge time	8hour(s)
Expected Battery Life (years)	43164
Communications & Management
Control panel	LED Status display with On Line : On Battery
Audible Alarm	Alarm when on battery : distinctive low battery alarm : overload continuous tone alarm
Physical
Maximum Height	92mm, 9.25CM
Maximum Width	160mm, 16.05CM
Maximum Depth	305mm, 30.5CM
Net Weight	5.7KG
Shipping weight	6.0KG
Shipping Height	237mm, 23.7CM
Shipping Width	143mm, 14.3CM
Shipping Depth	373mm, 37.3CM
SCC Codes	1073130433822 9
Environmental
Operating Temperature	0 - 40 °C
Operating Relative Humidity	0 - 90 %
Operating Elevation	0-1968.3meters
Audible noise at 1 meter from surface of unit	40.0dBA
Conformance
Approvals	CE
Sustainable Offer Status
RoHS	Compliant
REACH	REACH: Contains No SVHCs