EP-LS-2024B specification sheet

Overview:

 LS2024b

New landstar series is epsolar's new generation programmable solar charge controller. All the models adopt aluminum heat sink which enables the reliability in high temperature enviroments.Rs-485 connects to a remote meter or pc for real-time monitoring, custom setting and control etc.

Features:

• Three system voltage configuration : 12v, 24v or 12v/24v auto work
• High efficiency pwm charging with temperature compensation
• 3 leds shows pv charging, battery and load status
• External temperature sensor interface
• Rs-485 bus communication
• Open standard modbus communication protocol
• Software update function

More powerful function via mt50 or pc

• Diversified load control modes : manual, light on/off, light on+ timer, time control
• Battery type selection: gel, sealed, flooded and user type
• Real-time monitor
• Programmable parameters
• Lvd or soc load disconnect function
• Energy statistics function

Electronic protections

• Pv short circuit
• Pv reverse polarity
• Battery overcharge
• Battery over discharge
• Battery reverse polarity
• Load short circuit
• Load overload
• Overheating

Specifications:

© 2026 Respective owners and brand holders. This table has been carefully researched and generated by ComXpert International CC (//www.comx-computers.co.za), however, errors and omissions may occur. Only references to South Africa apply. All products are sourced in South Africa from the official suppliers and the warranty is that of the local supplier. E&OE. This table and our site's content may be used on condition that this notice and link remains intact and unaltered.
Specifications and features
Product Code	EP-LS-2024B
Nominal System Voltage	12 / 24V auto work
Rated Battery Current	20A
Maximum battery voltage	50V
Grounding	Common positive
Self-consumption	8.4mA(12V)，7.8mA(24V)
Temp. compensation	-3mV/ /2V（25 ref）
Equalize charging voltage	Sealed: 14.6V, Flooded: 14.8V, User-defined: 9~17V
Boost charging voltage	Gel: 14.2V, Sealed: 14.4V, Flooded: 14.6V, User-defined: 9~17V
Float charging voltage	Gel /Sealed /Flooded: 13.8V, User-defined: 9~17V
Low voltage reconnect voltage	Gel /Sealed /Flooded: 12.6V, User-defined: 9~17V
Low voltage disconnect voltage	Gel /Sealed /Flooded: 11.1V, User-defined: 9~17V
Working temp.	-35 ~+55
Humidity	≤95% (NC)
Enclosure	IP30
Dimension	159.6x81.4x47.8mm
Terminal	4mm2 : 10mm2
Net weight	0.3kg