KIN-1500RM specification sheet

Complete protection for internet computers and advanced servers.

Features :

• Line interactive design
• Fully digitized microprocessor controlled
• Tel/modem internet surge suppression
• Boost and buck AVR
• EMI/RFI noise filter
• Surge protection output for critical load
• On-line, back up, battery fauel status LED
• Lightning and surge protection
• Short circuit and overload protection
• 50/60Hz frequency auto sensing
• Advanced battery management (ABM)
• Energy saving (UPS sleep mode)
• Smart RS-232 communication port
• AVR boost & buck LED
• Cold start (DC power on)
• Automatically charging when UPS off
• History record of power failure events
• Schedule shutdown & reboot
• Back up, on-line, battery status, power status display by software
• Hot swappable battery by users

© 2026 Respective owners and brand holders. This table has been carefully researched and generated by ComXpert International CC (//www.comx-computers.co.za), however, errors and omissions may occur. Only references to South Africa apply. All products are sourced in South Africa from the official suppliers and the warranty is that of the local supplier. E&OE. This table and our site's content may be used on condition that this notice and link remains intact and unaltered.
Specifications and features
Product Code	KIN-1500RM
MODEL		KIN-1500AP RM	KIN-2200AP RM	KIN-3000AP RM
INPUT	Capacity (On Battery)
	Capacity (Surge Protection outlets)	500VA (for 20~240V models only)
		+/-25% at line input
		50 or 60 Hz +/-10% (auto sensing)
OUTPUT	Voltage (on battery)	Simulated sine wave at 100V or 110V/115V/120V or 220V/230V/240V +/-5%
	Frequency (on battery)	50 or 60 Hz +/-0.5%
	Voltage Regulation (AVR)	AVR automatically increase output voltage 15% above input voltage if -9% to -25% of nominal. AVR decrease output voltage 13% below input voltage if +9% to +25% of nominal
	Transfer Time	2/4 milliseconds, including detection time
PROTECTION & FILTERING	Spike Protection	320 Joules
	EMI/RFI Filter	10dB at 0.15MHz, 50dB at 30MHz
	Unit Input	For overload & Short circuit protection
	Overload Protection	UPS automatic power off if overload exceeds 110% of nominal at 60 seconds and 130% at 3 seconds
	10 Base-T Cable Port	Network (UTP, RJ-45) compatible jacks
	Short Circuit	UPS output cut off immediately or input circuit breaker protection
BATTERY		Sealed, Maintenancd-free lead acid
	Typical Recharge Time	8 hours (to 90% of full capacity)
	Back-up Time (a PC with 15" monitor)	70 - 80 mins	85 - 95 mins	95 - 105 mins
		Automatic self-test, Discharge protection, Replace battery indicator
PHYSICAL	Net Weight Kg(lbs)	16.0 (35.2 lb)	28.0 (61.6 lb)	32.7 (71.9lb)
		18.5 (40.7 lb)	30.7 (67.5 lb)	36.3 (79.8lb)
	Dimension WxDxH (mm)	483 x 357 x 84 (2U)	483 x 351 x 130 (3U)
INTERFACE		RS-232C Bi-directional communication port
ALARM	Battery Back-up	Slow beeping sound (about 0.47 Hz)
	Battery Low	Rapid beeping sound (about 1.824 Hz)
		Continuously beeping sound
ENVIRONMENT	Ambient Operation	3,500 meters max, elevation. 0-95% humidity non-condensing, 0-40 ¢J
	Audible Noise	<40dBA (1 meter from surface)
	Storage Condition	15,000 meter max