PCM-IMD-625AP specification sheet

Overview:

Powercom Line Interactive UPS -  Imperial Digital series  (625VA)
The Powercom Imperial Digital UPS with AVR (Automatic Voltage Regulation) will provide protection against surges, spikes and lightning strikes and battery backup in case of power failure. The unit features a digital LED indicator which displays the output voltage and battery level.

• Elegant design with digital LED indicator displaying battery capacity and output voltage
• Built-in automatic boost and buck AVR (Auto voltage AVR) 
• Simulated sine wave output waveforms
• Green mode setting for energy saving
• Automatic self-diagnostic and alarm warnings
• Surge, short circuit, and overload protections
• Discharge and overcharge protection
• Scheduling shutdown & reboot function
• Events recorder of power incidents

IMPORTANT Warranty NOTICE:

The LEAD ACID Batteries contained within this UPS device are rated to last 150-200 cycles. The life cycle refers to the battery being depleted completely and charged back up to 100% capacity. We strongly recommend not to deplete the battery's charge below 50% as this could damage the battery's lifecycle and will result in the battery's ability to function normally for only 2 - 3 months.

These batteries are not designed to keep devices powered during an entire load shedding schedule, but rather to enable the user to have time to shut down devices (PC's, Laptops) safely. Therefor during a power outage and loadshedding schedule we recommend shutting down the UPS after all connected devices have been shut down safely.

Specifications:

© 2026 Respective owners and brand holders. This table has been carefully researched and generated by ComXpert International CC (//www.comx-computers.co.za), however, errors and omissions may occur. Only references to South Africa apply. All products are sourced in South Africa from the official suppliers and the warranty is that of the local supplier. E&OE. This table and our site's content may be used on condition that this notice and link remains intact and unaltered.
Specifications and features
Product Code	PCM-IMD-625AP
UPS Specs
Input Voltage	100V / 110V / 120V ±25% 220V / 230V / 240V ±25%
Input Frequency	50Hz / 60Hz ±10% auto sensing
Output Connections	5 x IEC Sockets
Output Voltage (Backup mode)	100V / 110V /115V / 120V (±5% on battery) 220V /230V / 240V (±5% on battery)
Output Frequency (Backup mode)	50Hz / 60Hz ±1%
Output Waveform	Simulated sine wave
Output Transfer Time	2 to 4 millisecond including detection time (typical)
Automatic Voltage Regulator (AVR)	AVR with 1 step boost and 1 step buck
Overload Protection	Auto power off if overload exceeds 110% of nominal at 60 seconds, 130% at 3 seconds
Unit Input Protection	Fuse or overload & short circuit protection
Tele-communication Protection	N/A
Alarm	Buzzer beeps under backup mode, battery low, battery charging fault, and overload
Battery Type	Sealed, maintenance-free lead acid battery
Typical Recharge Time	6 hours to 90%
Battery Quantity	12V 7Ah x1
Battery Protection	Automatic diagnostics, over-discharge and short circuit protection
Display	LED - Indicates output voltage and battery levels
Communication Interface	N/A
Audible Noise	< 40dBA (1m from surface)
Ambient Operation	Max elevation at 2000m, 0 to 40C, 0 to 95% humidity (non-condensing)